Well that went….

So, we moved into our new house! It’s still not finished, but we’re in it. And things have gone…okay. There’s this deep excitement which I (we) get flushes of.
“We built this!”
“Ooooh, I’ve not seen that angle before, it’s pretty”
“Oh hey! You can see the moon through the skylight!”

Stuff like that.

There’s moments of deep joy. Stuff that works. The washer and dryer doing their stuff without any drama (at least so far). The moment we first switched the cooker on.

Taking a bath…

Laying in our bed at night, looking up at the ceiling that we built in the house we rebuilt… it’s crazy, but it’s cool.

And then there’s the less positive stuff. I’ve realised I didn’t load balance the panel properly. I think it was so long after I did the diagrams and worked it out, that I just went “oh, I could put this here” for the car chargers and the dryer and the oven and reverted to my UKian ways.

Which means that the car chargers and the cooker and the dryer were all on one phase.

Ooops.

I’ve managed to move one of the car-chargers across, but there’s not quite enough length to get either the cooker or the dryer circuit across. I am debating whether to splice some extra length onto the dryer circuit – that’s the easiest to move, and it would make it so that we have dryer/charger on one side and cooker/charger on the other. At any rate, I need to get some blanking plates for the panel. Made worse, because I accidentally took out the wrong flipping covers when I moved the car charger’s breaker.

Irritatingly, the 50AFCI/GFCI breaker that we have seems to be faulty. It’s tripping without purpose. I initially thought maybe it was the damp weather and the tight box that the outlet is crammed into, but it turns out that no. It’s just tripping. I’m leaving that for when I’m next in the panel though – and when we have a second charger. We currently only have one anyhow, so since the 40A breaker is fine, so it is kind of a moot point right now.

We’ve also been working on installing the kitchen – basically one unit at a time we’re creeping down the kitchen. Laughably, I thought we might be able to do it the day after we moved… Oh, the foolishness of youth. We worked all day yesterday and got the two long units installed. And managed to get the temporary sink dropped into the temporary work surface. I then spent much of this morning working out how to plumb it in, only to discover that it leaks from a tiny rusthole which is invisible from the top of the sink, but apparently, someone decided it was okay to give a broken sink to habitat and after a while it just quietly starts dripping.

The main drain side of the sink also seems to have started leaking, hilariously. I’m going to go tomorrow and get a new washer for that one. But I can’t say that I’m the happiest bunny in the world.

Now we just need to get the cooker leveled and then the 18″ unit next to it…

The dishwasher is looking like it might fit…if only I can get the fucking thing to turn on. It’s a used dishwasher that was allegedly working when it was sent. It’s in good condition, but it doesn’t appear to want to start it’s cycle. It illuminates the “yes, I’m on” and “this is the cycle you’ve selected” lights. It just doesn’t start. Now, my guess is that the door-sensor switch is fubar, but that means taking the dishwasher apart which wasn’t high up my priority list.

There’s a slim possibility I might cave and pay for someone to come look at the dishwasher. It’d be convenient if one of the things – either the sink or the dishwasher was working, though. Still, I’ve actually had coffee today, so that’s nice. And we finally have drinking water available in the house (even if I did plumb the tap backwards – so hot is where I think cold should be).